基于SAP系统中自动扶梯装配型材配置优化的研究

 吴建龙

(通力电梯有限公司,江苏 昆山 215300)
摘要:根据自动扶梯的特征值、型材装配工艺要求及包装运输技术规范,导出了自动扶梯直线段型材实际需要装配长度的配置计算公式,通过在SAP系统中进行配置方法的优化,避免了因系统配置6 m长型材需要进行实配切割而造成的浪费现象,从而降低了自动扶梯装配型材的报废率。在确保产品装配方法不变的前提下,通过改善SAP系统配置方法来实现缩减制造成本。
关键词:自动扶梯;型材;配置优化;SAP系统
中图分类号:TU857 文献标志码:A doi:10.3969/j.issn.1006-0316.2018.11.014
文章编号:1006-0316 (2018) 11-0056-06
Research on Configuration Optimization of Escalator Assembly Profiles Based on SAP System
WU Jianlong 
( KONE Elevator Co., Ltd., Kunshan 215300, China )
Abstract:This method is to create the calculation formula of the assembly length of escalator linear profile according to the characteristic value of escalator, the requirements of assembly process and the technical specification of packaging and transportation, and then optimize the configuration method in SAP system. It avoids the waste caused by the SAP system configuration of 6 meters long profile that needs to be cut to the actual length, Which reduce the scrap rate of escalator assembly profiles. It provides an example to reduce manufacturing cost by improving configuration in SAP system without change of assembly process.
Key words:escalator;profiles;configuration optimization;SAP system
———————————————
收稿日期:2018-01-22
作者简介:吴建龙(1964-),男,江苏昆山人,生产智能中心主管,主要从事自动扶梯设计及制造工艺的改进研究工作。
 

 

设为首页  |  加入收藏    |   免责条款
《机械》杂志版权所有     Copyright©2008-2012 Jixiezazhi.com All Rights Reserved 

  电话:028-85925070    传真:028-85925073    E-mail:jixie@vip.163.com

地址:四川省成都锦江工业开发区墨香路48号   邮编:610063

Powered by PageAdmin CMS