基于ANSYS WorkBench一字型转轴扭矩分析

 王强

(苏州经贸职业技术学院,江苏 苏州 215009)
摘要:通过ANSYS WorkBench中瞬态动力分析模块对新型一字型转轴进行了扭矩分析,分析中,锥片变形设为非线性,根据实际情况设置了接触面的摩擦因数。分析结果表明,在转轴工作过程中,锥片均为弹性变形,变形不均匀,摩擦应力分布不均匀,锥片与轴套绝大部分处于滑动状态,小部分会产生粘连,接触面之间几乎没有穿透,锥片与轴套间的摩擦力随着轴芯位置呈现非线性增大,并得出转轴扭矩与轴芯位移之间的非线性变化曲线。
关键词:转轴;扭矩;有限元分析;摩擦;ANSYS WorkBench
中图分类号:TP303 文献标志码:A doi:10.3969/j.issn.1006-0316.2018.07.006
文章编号:1006-0316 (2018) 07-0025-03
Torque Analysis of Linear Type Hinge Based on ANSYS WorkBench
WANG Qiang
( Suzhou Institute of Trade & Commerce, Suzhou 215009 , China )
Abstract:Torque analysis of linear type hinge by transient structural in ANSYS WorkBench, in the analysis, the deformation of cone pieces is nonlinear, the friction coefficient of the contact surface is set up according to the actual situation. Analysis results show that cone pieces are elastic deformation, inhomogeneous deformation, friction stress distribution is not uniform, the vast majority of cone pieces and sleeve in sliding state, small part will produce adhesion, little penetration between the contact surfaces, the friction force between the cone pieces and the shaft sleeve increases nonlinearly with the central spindle displacement, the nonlinear curve between the torque of the hinge and the displacement of the spindle is got.
Key words:hinge;torque;finite element analysis;friction;ANSYS WorkBench
———————————————
收稿日期:2017-10-12
基金项目:苏州经贸职业技术学院自然类项目(KY-ZR1709)
作者简介:王强(1981-),男,江苏徐州人,硕士研究生,讲师,工程师,主要研究方向为机械设计与制造。
 

 

设为首页  |  加入收藏    |   免责条款
《机械》杂志版权所有     Copyright©2008-2012 Jixiezazhi.com All Rights Reserved 

  电话:028-85925070    传真:028-85925073    E-mail:jixie@vip.163.com

地址:四川省成都锦江工业开发区墨香路48号   邮编:610063

Powered by PageAdmin CMS